Leonard LAI8001F Benutzerinformation Seite 32

Problem
You can hear a constant beep
noise.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Automatic Heat Up does not
operate.
The heat setting changes be‐
tween two levels.
The control panel becomes
hot to the touch.
comes on.
comes on.
32 ENGLISH
Possible cause
You do not set the heat setting for
10 seconds.
You touched 2 or more sensor
fields at the same time.
Pause operates.
There is water or fat stains on the
control panel.
The electrical connection is incor‐
rect.
You put something on one or
more sensor fields.
You put something on the sensor
field .
The zone is not hot because it op‐
erated only for a short time or the
sensor is damaged.
The highest heat setting is set.
The zone is hot.
Power management operates.
The cookware is too large or you
put it too close to the control pan‐
el.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the
zone.
Remedy
Activate the hob again and set the
heat setting in less than 10 sec‐
onds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
The highest heat setting has the
same power as the function.
Let the zone become sufficiently
cool.
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".