Cleaning And Maintenance - Ohyama WOOZOO SCD-130P Bedienungsanleitung

Black

Cleaning and maintenance

● Be sure to stop operating the unit
and unplug the charging adapter
each time before cleaning.
● Do not wet the cleaner and charging
adapter. Failure could cause an electric
shock, an injury, or a malfunction.
● Do not use cleaning solvent, thinner, benzene, or
bleach.
● Do not use a chemically-treated cleaning cloth.
Main unit, exterior of the floor
head and the thin nozzle
About once a week
• Wring soft cloth soaked with water or lukewarm water
(below 40 o C) well and wipe off any stains.
• If it is hard to remove a stain, wipe it off with a soft cloth
soaked with dishwashing liquid and wipe it again with
the cloth wrung out nearly dry so that the dishwashing
liquid does not remain.
Floor head/extension pipe
when it is clogged with dust
• If dust is tangled in the soft roller brush or suction port,
remove it with tweezers.
Soft roller brush
• If the inside of the floor head or extension pipe is
clogged with dust, the suction power declines. Check
the inside of the floor head or extension pipe periodically
and remove any dust with tweezers or use disposable
chopsticks if it is clogged with dust.
Dust sensor
Clean the dust sensor once a week
• Wipe the sensors on the left and right of the suction
port with a cotton bud or finger covered with tissue
paper, etc.
• If dust adheres to the sensor, such dust may
cause a malfunction. Accordingly, clean the sensor
periodically.
Sensor (left and right)
13
EN
SCD-130P