Ytora TPW899 Handbuch Seite 4

Mounting the rain
3. Mounting Mounting the Mounting the the rain rain sensor rain
lines at the bottom edge of the round cover and the sensor part, you only need adjust
the two line into one position, then turn clockwise, the rain sensor part will be connected
well, then fix them with 4 screws onto the plastic bracket ( don't use only 2 screws )
please follow the below display：
Mount the thermo-hygro
4. Mount Mount the Mount the the thermo-hygro thermo-hygro sensor thermo-hygro
and rain sensor are fixed onto the bracket, connect the cables to the corresponding
thermo-hygro sensor sockets with the plugs, so that data can be transmitted to the main
unit, then put the aspiration cover onto the thermo-hygro sensor, please follow the below
display:
Note Note Note: please don't connect/disconnect the plugs too often nor put the plug outside in the Note
air for longer time in order to avoid any damage to the plugs. Otherwise the
connection can be affected negatively!
sensor sensor to to to to the the second
sensor the second the second plastic second
sensor sensor to to to to the the
sensor the third the
plastic bracket:
plastic bracket: plastic bracket: bracket: there are vertical engraved
third plastic bracket:
third third plastic plastic bracket: plastic bracket: once the wind sensors bracket: