Outdoor sensor:
•
Frequency: 433 MHz
Transmission range: 100 meters in open area.
•
Note: Actual distance may vary depending on the environment, it will be shortened in real
buildings due to electrical interference, concrete walls etc.
Batteries: 2 x AA, LR6 1.5V (not included)
•
Installation
Installation
Installation
Installation
Installing
Installing
the
the
• • • •
Installing the
Installing
the Batteries
Open the main unit battery cover located at the back of the main unit and insert 3 pcs AA
•
batteries into the battery compartment and close the battery cover.
Pull away the radiation shield from the thermo-hygro sensor to reveal the 2 sockets (the
•
sockets for the wind sensor and rain sensor)
1. Connect the wind speed sensor cable into the socket at the bottom of the of the wind
•
direction sensor
2. Connect the cable from wind direction and the cable from rain sensor to the
corresponding sockets of the thermo-hygro sensor by clicking them into place.
Make sure that rain and wind cables are connected to the correct sockets.
3. Open the battery cover and insert 2 pcs AA batteries into the battery compartment and
close the battery cover.
Batteries
Batteries
Batteries