Pneumatic Sander And Polisher Safety Instructions - Hamach DS30 Gebrauchsanleitung

Pneumatic Sander and Polisher safety instructions

The goal of Hamach pneumatic tools is to offer tools that help you work safely and efficiently. The most
important safety device for this or any tool is YOURSELF.
Your care and good judgment are the best protection against injury. All possible hazards cannot be covered
here, but we have tried to highlight some of the important ones. This tool and its accessories must not be
modified. This tool may only be use by qualified people.
For additional safety information consult:
 The instruction manual and any leaflet packed with this tool.
 Your employer, union and/or trade association.
 Council of the European communities and/or local codes.
" Safety requirements for hand-held non-electric Power Tools ". Available from: European committee

for standardization, Rue de Stassart 36, 1050 BRUSSELS, BELGIUM.
Air supply and connection hazards:
 Air under pressure can cause severe injury.
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply, when not

in use, before changing accessories or when making repairs.
Put never direct air at yourself or anyone else.

 Whipping hoses can cause serious injury. Always check for damaged or loose hoses and fittings.
 Do not exceed maximum air pressure of 6.2 bar or as stated on the name plate.
 Do not use quick disconnect couplings at tool. See instructions for correct set-up.
Entanglement dangers:
Keep away from moving sanding pad.

 Do not wear jewels or loose clothing and avoid long hair.
 Choking can happen if neckwear is not kept away from tool and accessories.
 Scalping can happen if hair is not kept away from tool and accessories.
Avoid direct contact with accessories during and after use. Gloves will reduce the risk of cuts or

burns.
Projectile hazards:
 Even small projectiles can injure eyes and lead to blindness.
Always wear impact-resistant eye and face protection when involved with or near the operation,

repair or maintenance of the tool or changing accessories on the tool.
 Ensure all others in the area are wearing impact-resistant eye goggles and face masks.
 Never operate the tool while not applying onto the articles. It may run too fast and lead to the
accessory to be thrown off the tool.
Workplace hazards:
Slip, trip and fall are main causes of serious injury or death. Be aware of excess hose left on the

path or work surface.
 Maintain a balanced body position and secure footing.
 High sound levels can lead to permanent hearing loss. Use hearing protection as recommended.
 Avoid breathing in dust or handling debris from work process which can be harmful to your health.
Operators and maintenance personnel must be physically able to handle the bulk, weight and power

of this tool.
 This tool is not intended for use in explosive atmospheres and is not insulated for contact with
electric power sources.
Additional safety topics:
This tool and its accessories must not be modified.

Be prepared that the material your tool is made always can have material tiredness.

 Never use this tool in explosive atmospheres.
 Take care, the rotation of sanders is always to the right.
 Grinding and cutting wheels must not be used with sanders.
Connect your sander always on a dust collecting bag or suction installation.

10