Technical Information; English; Operating The Sanding Machine; Maintenance - Hamach DS30 Gebrauchsanleitung

Read these instructions before operating the tool.
WARNING !! DO NOT DISCARD – BUT GIVE TO USER WARNING !!

Technical information

DS 30
Size of pad Ø 30 mm
20 x 45 mm
15 x 60 mm
Free Speed 16.000 rpm
Air Inlet ¼ inch
Work Pressure 6.3 bar
Air consumption 350 L/min
Weight 1.2 kg
Air supply requirements
Supply tool with 6.0 bar of clean, dry air. Higher pressure drastically reduces tool
life and/or can cause severe injury.
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram above.
Do not install a quick coupler directly into the air tool throttle handle.
In order to have the tool working to full satisfaction the minimum air delivery must be at least 10% higher
than the indicated air consumption of they air tool.
Please consult the technical data in this instruction manual.

Operating the Sanding machine

DS 30
This is a vibrating sander for polishing intricate places and removal of small irregularities in fresh paint.
The small mini strips are fastened with Velcro to the base of the sander.
For micro discs another pad must be mounted. These micro discs are fastened with Velcro or self adhesive
material.
In order to mount a sanding base the metal base snatch must be placed in the machine slide way and glided
till the ring is clamped over the nut.
To loosen the base, the snatch must be lifted and the whole base glided forward.
DS 40
This machine is suited for efficient and simple removal of small irregularities and dried paint runs. The small
support pad (022301) is easy to mount by turning it in the machine
shaft. Due to the small eccentric movement of this mini sander, the polishing scratches will be minimized but
this is possible only if the correct structure of micro sanding discs is used.
After removing the irregularities, the small scratches can be removed with a mini polishing machine.
DS70
This pneumatic mini polishing machine is suited for polishing small areas e.g door posts and spot repaired
surfaces. The support pad which is included, can be a guide when choosing a foam pad (010057) or a fleece
(007807) for polishing : use the correct polish for the best result !
Lubrication
Use an airline lubricator with the oil set at two (2) drops per minute.
If an airline lubricator can not be used then once a day add 1 to 2 drops special air motor oil into the air
inlet.

Maintenance

Disassemble and inspect air motor and governor assembly every three months if the tool is used every day.
We prefer that you use our distributor to replace damaged or worn parts.
Please use the spare parts list as a guide manual when dismantling or assembling the tool.
High wear parts are indicted as service kit in the parts list. To reduce risk of injury, everyone using,
installing, repairing, maintaining, changing accessories on, or working near this tool must read and
understand these instructions before performing any such task.
DS 40 DS 70
Ø 30 mm Ø 70 mm
16.000 rpm 2.500 rpm
¼ inch ¼ inch
6.3 bar 6.3 bar
350 L/min 350 L/min
0.7 kg 1.1 kg

English

9