Setting The Channel; Activating / Deactivating The The Temperature And Frost Alarm - Weinberger 40283 Bedienungsanleitung

level or get the current value from the Internet. You can adjust the weather station
like this:
Press and hold the HISTORY ABS / REL button for approx. 3 seconds. After that
press the + or – -button to interchange between the absolute or relative air
pressure.
Chose „Rel" and press the HISTORY ABS/REL button for confirmation. The air
pressure indication blinks. Now you can chose the correct value by pressing the +
or – -button.
Confirm your choice by pressing the HISTORY ABS / REL button. Your weather
station now shows the relative air pressure.
Press and hold the HISTORY ABS / REL button for approx. 3 seconds. Afterwards
press the + or – -button, to change to the absolute air pressure. Confirm by
pressing the HISTORY ABS / REL button.

Setting the channel

The weather station receives the outdoor sensor signal automatically after you have
made all the settings. The symbol for humidity (outdoor) and outdoor temperature
flashes during this time.
- 1: Outdoor sensor channel 1
- 2: Outdoor sensor channel 2
- 3: Outdoor sensor channel 3
- : automatic channel change
Displaying the maximum / minimum temperature /
humidity
The minimum / maximum temperature / humidity is measured for the first time
after the batteries have been inserted and stored in the weather station.
The maximum and minimum values for temperature, hygrometer and barometric
pressure are automatically saved.
If the weather station is in time display , press the + button to display the
maximum values.
Press the + button twice to display the minimum values.
Hold the + button down for approx. 3 seconds to erase the stored maximum
and minimum values.
Temperature and frost alarm
The temperature alarm is a short beep, which sounds as soon as the outdoor
temperature exceeds or falls below the preset temperature range. Follow the below
procedures to set the desired temperature range.
Press the – button to get top the temperature alarm mode.
Hold the – button down for 3 seconds. The maximum temperature display blinks.
Press the + or – button to set the values.
Press the MODE button to confirm your setting. The minimum temperature display
blinks. Press the + or – button to set the values.
Press the MODE button to confirm your setting.
Activating / deactivating the the temperature and frost
alarm
If more than one outdoor sensor is activated, press the channel button to select
one.
25