clearaudio electronic Unify Bedienungsanleitung Seite 9

User manual / Bedienungsanleitung
3. Carefully remove the security zip tie and unwrap the arm tube.
Caution: Once the security zip tie is removed pull it out of the armwand with reasonable care.
Now, place the arm tube on to the pivot point and lock it into it´s arm rest. Use the cable strain
relief screw and washer to secure the cable to the tonearm base.
Pic. 4: Placing the arm tube to the pivot point
Slide the Clearaudio
4.
Lock the weight in it`s position by tighten the screw in the weight.
This is onlay a temporary position, the final adjustment wll be done during cartridge installation.
Turbo Weight
Pic. 6:
5. Mount your cartridge according to the manufacturer´s instructions.
6. Use the Clearaudio
AC089) to set tracking force (see cartridge instructions for recommended tracking force renge).
Adjusting tracking force is accomplished by moving the weight towards or away from the pivot
point on the shaft.
Note:
When tightening the counterweight, insure that the weight is perfectly vertical otherwise
this may affect your cartridges azimuth settings.
7. Align cartridge for overhang and offset angle using the Clearaudio
(Art. No.AC005/IEC). Once done, re-check tracking force.
8. Feed the anti-skating weight through the anti-skating support wand and secure it to the threaded
shaft at the top of the tonearm bell.
point is equal to approx. 0.5g of anti-skate. Each additional 1/8" out on the shaft will give you
another 0.5g of anti-skating force with a maximum of 3.0g if affixed to the end of the shaft.
Made in Germany
Pic. 5: Detail: Cable strain relief screw
Turbo Weight
on the shaft of the tonearm.
Weight Watcher
( Art.No. AC094) or the
Note: Attaching the string to the position closes to the pivot
Smart Stylus gauge
Cartridge alignment gauge
Page / Seite 9
(Art.No.