Operation - Sonnenkönig CUBY Bedienungsanleitung

2 Operation

Plug the heater into the socket. Make sure there are no flammable materials within a two-metre
EN
radius.
0 OFF
Fan only, no heat
I Low heat output (750 Watt)
II Full heat output (1500 Watt)
Thermostat
The thermostat will only work on the stages I and II. Turn the thermostat clockwise to increase
the heating power.
Use of ventilation
• Turn the control dial to «FAN». The fan will blow air out at room temperature.
• If the fan does not operate, the ambient room temperature is cooler than the «OFF» level of
the built-in thermostat. gradually turn the thermostat dial clockwise and the fan will start
blowing.
• As soon as the fan starts, the light in the front of the machine will illuminate.
To use the machine for heating
• Turn the control dial to «I» for low heat or «II» for full heat.
• Set the heat level by gradually turning the thermostat dial clockwise for the lowest heat and
fully clockwise for maximum heat.
• The thermostat will turn the machine off when the set room temperature is reached. When the
temperature drops, it will turn on again automatically.
• For maximum heat output use «II» with the thermosat turned fully clockwise.
Overheating
• The thermostat will turn the machine off in case it overheats.
• Overheating can be caused by blocked air intakes on the back of the machine or a blocked grill
on the front. If this occurs, please disconnect the machine and allow it to cool for 30 minutes.
Clear the blockage and turn the machine back on.
• If the heater ceases to function, the most likely cause is a blown fuse. Simply replace the 13amp
fuse in the plug and reconnect. If there is still no function please follow the repair advice
above.
All manuals and user guides at all-guides.com
36