Reset The Device; Device Status; Battery Replacement; Maintenance And Care - BeeSecure BEE-MS Bedienungsanleitung

V1.0
• Avoid installing the motion sensor in areas where the temperature might change rapidly, e.g.
air conditioners, heaters etc.

4.Reset the Device

If the device is not functioning, you can try to reset the device by long pressing the button on the
motion sensor for more than 5 seconds until the LED light flashes in red, release the button now.
After resetting, the motion sensor will flash once in red to indicate reset has been successful. The
device is now restored to manufacturing settings but all the data stored on the BeeSecure cloud will
remain, including device name and history messages.

5. Device Status

The status of the LED on the motion sensor indicates the device status.
LED
Flash green for 3 times
Flash once in red
No flash
Flash once in green

6. Battery Replacement

Whenever the battery level of the motion sensor is low, you will receive a notification on the app.
You can easily replace the battery following the same steps used when installing the battery. After
replacing the battery, all user data including history message, sensor settings will remain. You will
not lose any data.

7. Maintenance and Care

1. Carry out a test by moving within the detection range of the motion sensor weekly to ensure
the device is functioning
2. Do not touch the sensor screen to avoid impacting the sensitivity accuracy
3. Avoid high humidity areas which can cause condensation
4. Relocate the motion sensor if it generates unwanted alarms. Refer to section 3 on 'Mounting
Locations' for more details on which locations to avoid
5. Clean the sensor at least once every couple of months with a dry or slightly damp
microfiber cloth
Battery Activated
Motion Detected
Reset succeeded
Working/Normal
Pair with BEE-HUB succeeded
www.beesecure.eu
Device Status
English