Caution ! Hazard of serious burns when running the hot plate over 50°C.
Avoid contact with hot plate, tank and fluid.
Caution ! When heating flammable substances, adjust hot plate nominal
temperature to a lower level than the substance's flashpoint.
Your item needs a solid stand.
1.
Setting Up the EKT 3001
1.1.
Fitting the holding rod
• Unscrew the black cap (1) and remove from
the top of the magnetic stirrer.
• Screw the holding rod (2) in the same hole.
1.2.
Fitting the temperature controller
• Press the clip (4) into the holes on the back
of the EKT 3001 until it latches in place.
• Push the clip over the holding rod. (With Ø
10 mm, the tab (3) has to be folded over).
• Slide the bracket (6) onto the holding rod
(2). (The sensor bracket can be ordered as
an accessory).
• Fix in the correct position with the knurled
screw (5).
• Push the sensor (1) into the bracket (6)
from above or from the front.
SET-UP
19
E