Subwoofer Connection - Grundig DSB 990 Bedienungsanleitung

PREPARATION/CONNECTION
Preparation
Activate the remote control battery
1
Remove protection film from the battery com-
partment.
– The remote control is now functional.
Change remote control batteries
(TYPE AAA)
Note:
If your device no longer responds to the
7
remote control commands, the battery may
be dead. It is imperative that dead batteries
be removed. We do not assume liability for
damage caused by leaked batteries.
Caution:
Danger of explosion if battery is incorrectly
7
replaced. Replace only with the same or
equivalent type.
1
Hold the remote control with the back side fac-
ing up.
2 Push the detent of the battery holder to the right
and remove battery holder.
3
Remove used battery and insert new battery
into the battery holder, positive pole facing up-
ward.
4
Push battery holder into the remote control until
it clicks into place.
Connecting
Connect Soundbar to the LCD TV
1 Connect a standard audio lead to the
»AUX INPUT« jacks of the Soundbar.
– Please be aware of the left and right chan-
nels when doing so (white = left channel,
red = right channel).
2
Connect audio lead to the audio output jacks
of the LCD TV.
Connect external device
An external device, such as a MP3-Player for ex-
ample, can be connected to the »AUX IN« jack.
1
Connect a standard audio lead to the
»AUX IN« jack of the Soundbar.
2
Connect adapter cable to the external device.
- ---------------------------------------------------------
Note:
The LCD TV can also be connected via the
7
»AUX IN« jack if it is not equipped with au-
dio output jacks. In such cases please use the
headphone jack.
Connect mains cable
Check that the mains voltage indicated on the
type label (on the back of the device) corre-
sponds to the local mains voltage. If this is not the
case, please consult your specialist dealer.
1 Plug mains cable plug into the socket
(100 - 240V ~ 50/60Hz).
Caution:
The Soundbar is connected to the mains via
7
the mains cable. If you want to disconnect
the Soundbar from the mains completely,
you must pull the mains plug.
Please ensure that the mains cable is freely
7
accessible during operation and is not ob-
structed by any other objects.
Subwoofer Connection
1
Make sure the AC power cord is connected to
a power supply securely.
2 Subwoofer have the wireless bluetooth to
receive the audio signal from the sound bar.
When the blue indicator flashing, the subwoof-
er is in searching bluetooth signal status, the
blue indicator keeps lighting means bluetooth
was connected, if the subwoofer can not con-
nect with the soundbase automatically, please
press pair button on the rear panel of subwoof-
er to reconnect.
3 The subwoofer will memories the sound bar
and repaired automatically when you power
off the subwoofer then power on.
GSS1010
DSB 990 2.1
Made in P.R.China
ENGLISH
19