Light Sensor; How To Use - SwitchBot W1101500 Benutzerhandbuch

Light Sensor

Light Sensor is used for detecting whether it is bright or dark in the target environment.
You can define the threshold for being bright or being dark in the app. Navigate to the
Settings page of Motion Sensor in the app for more information.

How to Use

Reset Button facing up
The recommended height to install Motion Sensor is 1.2m-2m to the ground. The
detection range will be reduced when it is placed lower than 1.2m. There will be
detection blind spots when it is placed higher than 2m.
Reset Button facing down (for Pet Owners)
If you are a pet owner, it is recommended to install Motion Sensor to a spot 0.1-0.2m
higher than your pet(s), with the Reset Button facing down. You can also install Motion
Sensor to a spot slightly lower than your chest to prevent false alarms triggered by your
pets.
Place Motion Sensor without the Base
Place Motion Sensor directly on a table or shelf or stick it to a flat surface using the 3M
Sticker.
Note: Make sure the Lens is facing towards the desired area to be detected and it is
placed close to the edge of the table or shelf.
8