Yuasa YCX1.5 Bedienungsanleitung Seite 6

Dual clamp to eyelet conversion
The charger is supplied with clamps that feature integrated eyelets. To convert the clamp
into an eyelet, simply remove the retaining screw and washer. To reattach the clamps, follow
this process in reverse (image 1).
1
The eyelets can be used for permanent connection to a battery whilst it is fitted in a vehicle.
They should be securely tucked out of the way and connected to the charger when using the
connection plug when charging is required (image 2).
Selecting the correct charging rate
This charger is designed for 6V and 12V conventional lead acid and LiFePO4 batteries.
The Ampere hours (Ah) capacities shown below are to be used as a general guide only.
Always refer to the battery manufacturer's specifications and recommendations for your
charging requirements. This charger is recommended for long term battery
maintenance.
Charge rate
Charging
Maintenance
LED Status
Amber
6V LED
ON
12V LED White ON
6V or 12V
Blinking
LED
Flash
ON
ON
YCX1.5
1.5A
2-30Ah
Up to 130Ah
LED charging indicators
Fast flash = 0.2s ON and 0.2s OFF
Blinking = 0.2s ON and 1.8s OFF
Flashing = 0.5s ON and 0.5s OFF
Descriptions
6V battery mode selected
12V battery mode selected
In eco mode
In soft start
In charging cycle, bulk charge or absorption
charge
In float and maintenance mode or fully charged
2
6