Yuasa YCX1.5 Bedienungsanleitung Seite 5

Connecting the charger to your battery
If the battery is out of the vehicle:
Connect the red lead from the charger to the positive (+) battery terminal.
Connect the black lead from the charger to the negative (-) battery terminal.
If battery is in the vehicle:
The below is a guide, please consult your vehicle's owner manual for information and
procedures on your specific vehicle.
Determine if the vehicle is positively or negatively earthed.
If negatively earthed (most common) - First connect the red lead from the charger to the
positive (+) battery terminal and then connect the black lead from the charger lead to the
vehicle's chassis and far away from the fuel line.
If positively earthed - First connect the black lead from the charger to the negative (-) battery
terminal and then connect the red lead from the charger to the vehicle's chassis and far
away from the fuel line.
Connect the battery charger to mains power
The charger will automatically start when mains power is connected and switched on.
(Note: If the LED fault indicator illuminates red, please check your connections as it is likely
that the positive and negative leads are reversed. Refer to Troubleshooting for further
information).
Disconnecting the battery charger from battery
If the battery is out of the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait for a minimum of
five minutes before disconnecting the charging leads.
Remove the black lead followed by the red lead.
Check electrolyte levels if possible. They may need topping up with distilled water after
charging.
If the battery is in the vehicle:
Switch OFF and remove the mains power socket from the outlet and wait for a minimum of
five minutes before disconnecting the charging leads.
Remove the lead from the vehicle chassis.
Remove the lead from the battery.
Check electrolyte levels if possible. They may need topping up with distilled water after
charging.
5