Agilent TwisTorr 305 FS Remote Controller Betriebsanleitung Seite 191

Technical Information
All the logic output from the controller must be connected at P2 mating connector.
The following table describes the signals available on the connector.
The following figure shows a typical logic output connection (relay coil) but any
other device may be connected e.g. a LED, a computer, etc., and the related
simplified circuit of the controller.
J 1
Minimum 1 kΩ
Figure 40 Digital Output Connection Example
1
Minimum 100 kΩ
2
Figure 41 Analog Output Connection Example
Agilent TwisTorr 305 FS Remote Controller User Manual 191