Technical Data - REV Ritter EMN406PIR Montage- Und Bedienungsanleitung

TECHNICAL DATA

• Output: 0,5W LED
• Illuminant: 1 SMD LED´s
• Luminous flux: 40lm
• Nominal values: 230V~; 50Hz
• Colour temperature: 3000K
• LED service life: 10000h
• Beam angle: 110°
• IP protection class: IP20
• Protection class: II (S8)
• Ambient temperature: 10°C – 30°C
• Dimensions W x H x D: 70 x 90 x 72mm
• Weight: 90g
• Coverage angle 90°
• Coverage area: 5m
• Continuous operation possible
• Switch-on brightness: 10lx
• Switch-on time: 60sec ± 15sec
• Recommended mounting height: 1m
INSTALLATION
• Please refer to the drawings for the installation steps.
• Plug into the wall socket (A1):
This socket should be located as centrally as possible in the area to be monitored. If the AUTO operating
mode has been selected, the device requires approx. 30 seconds until it is ready for operation.
• Setting the operating mode (A3):
The desired switching function (ON - OFF - AUTO) is set via the slide switch on the side.
ON: Permanently ON; The light is permanently switched on.
OFF:
Permanent OFF; The light is permanently switched off.
AUTO: AUTO motion detector mode
• Automatic switching only takes place in darkness from a fixed twilight level. In the event of heat
movement (e.g. by persons) in the monitored area, the light is switched on automatically. As long as
there is thermal movement, the light remains switched on. Approx. 60 seconds after no more movement
is registered, the light switches off.
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use
cleaners that contain abrasives or solvents.
MAINTENANCE
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service
life, the entire luminaire must be replaced.
GB
10