DHC BT2410 Benutzerhandbuch Seite 15

CABLE DIAGNOSIS
1. Select "CABLE DIAGNOSIS" to perform self diagnosis of the cable set.
2. Follow on screen instructions.
1. Clamp on a battery that the voltage is above 12.4V. And make sure its
posts are clean.
2. Press ENTER to start.
3. Select START to start the cable diagnosis.
4. Result will be shown on the Test Report, use left and right key to switch
between positive/negative cable test result explanation.
HISTORY
TEST RESULT
1. Select "HISTORY" and then enter "TEST RESULT" to review the test results
within the last 7 days.
2. Select between test types & days for reviewing.
3. Select "ERASE" will clear all the test records that saved in the tester.
TEST COUNTER
1. If the "TEST COUNTER" is selected. The user may review the number of the
tests that have been performed. Or print out the counter if needed.
DHC PC SOFTWARE
NOTE:
DHC PC Software can be found and installed at the following sources:
1. On the disc included in the box. (selected models only)
2. At our website, www.dhc.com.tw.
Navigation instruction: DHC website Support Download
15