Suntherm ALT Bedienungsanleitung Seite 9

MOUNTING
1. Make a hole in the plasterboard of a size adequate to
the heating panel type (see page 5).
3. Press the springs on the opposite side of the panel into vertical
position and tuck their ends above the plasterboard edge
DISMOUNTING
1. Turn off the power. Pull down the edge with springs.
Press the springs into vertical position and pull out of
the hole.
2. Make sure the electrical power is turned off and connect the panel into
the electrical mains using terminal block. Then slide the panel from the
spring-edge side onto the plasterboard edge.
4. Insert the panel carefully into the hole.
2. Disconnect the panel from power and take it out
from the hole.
9