Mode Setting - LF Bros T3 Benutzerhandbuch

Mode Setting

In the standby state, click the mode key to switch modes. Up button is to increase,
down button is to decrease.
1. When the screen displays P1.4Kw~P5.0Kw, it is the power mode. After adjustment, the
power will be fixed and the heater will continue heating (Figure6).
2. When the screen displays t 10°C~35°C, it is the temperature mode (Figure7).
(Figure 6) (Figure 7)
NOTE: The two modes can only be switched and cannot coexist. The last setting shall
prevail. For example, the previous setting of the power mode would be invalid if the
temperature mode is set.
Remote Control Matching
In the shutdow state (Figure 8), press and hold the mode key " " of the control switch
and the "OFF" key of the remote control at the same time.
The switch screen displays 433 (Figure 9), the buzzer sounds once, and the remote
control and the control switch are successfully matched.
NOTE: Normally the remote control matching has been completed before the heater
leaving the factory, and no further operation is required.
(Figure 8) (Figure 9) Remote control
7