Preparing The Printer - AgfaPhoto Realipix Pocket P Benutzerhandbuch

EN
BUTTONS AND LIGHT INDICATORS
Light
Button
Indicator
Light on: The printer is powered on but not connected to
Green
(charge the printer or it will shut down shortly)
Power
button
Light on: The printer is connected to Wi Fi
Blue
Flashing: No paper installed or out of paper
Paper
advancing Red
button

PREPARING THE PRINTER

1. Charging the battery
To charge the built-in battery, connect the printer to an external power source with the
provided USB cable. The minimum requirement for charging with a power adaptor* is 5V/1A.
*Not included
Note: It takes 3 hours or longer to fully charge the built-in battery.
7
Function
Wi-Fi
Slow flashing: Low battery
Fast flashing: Battery exhausted
(the printer is shutting down)
Light on: The device is charging
2. Installing The Printing Paper
a) Open the paper roll compartment cover.
b) Place the printing paper in its compartment and make sure the thermal sensing side
of the paper is facing towards the printer's thermal printing sensor as shown in the
illustrations below:
c) Firmly close up the cover.
OBTAINING THE COMPANION APP
This printer supports mobile phones on Android 5.0 or later, and iOS 10.0 or later.
The app can be downloaded by searching "PaperGo" on Google Play and the App Store,
or by scanning the QR codes found on the back of this manual.
EN
8