Declaration Of Conformity; Auxiliary Handle - Bosch GBH Professional 2-18 E Originalbetriebsanleitung

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
23.07.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.

Auxiliary Handle

Operate your machine only with the auxiliary
handle 10.
Rotating the Auxiliary Handle (see figure A)
The auxiliary handle 10 can be set to any position
for a secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxiliary
handle 9 in anticlockwise direction and set the
auxiliary handle 10 to the required position.
Then tighten the wing bolt 9 again in clockwise
direction.
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 11.
Press the button for the depth stop adjustment 8
and insert the depth stop into the auxiliary han-
dle 10.
The knurled surface of the depth stop 11 must
face downward.
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 1. Otherwise, the mova-
bility of the SDS-plus drilling tool can lead to in-
correct adjustment of the drilling depth.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.
Selecting Drill Chucks and Tools
For hammer drilling, SDS-plus tools are required
that are inserted in the SDS-plus drill chuck.
For drilling without impact in wood, metal,
ceramic and plastic as well as for screwdriving,
tools without SDS-plus are used (e. g., drills with
cylindrical shank). For these tools, a keyless
chuck or a key type drill chuck are required.
Changing the Key Type Drill Chuck
To work with tools without SDS-plus (e.g., drills
with cylindrical shank), a suitable drill chuck
must be mounted (key type drill chuck or keyless
chuck, accessories).
Mounting the Key Type Drill Chuck
(see figure C)
Screw the SDS-plus adapter shank 14 into a key
type drill chuck 13. Secure the key type drill chuck
13 with the securing screw 12. Please observe
that the securing screw has a left-hand thread.
English | 19
1 619 929 736 | (30.8.07)