Product Description; Packaging Content - LightPro Ixion 182W Bedienungsanleitung

Ixion
User manual
Thank you for purchasing the Lightpro Ixion.
This document contains the necessary information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.

PRODUCT DESCRIPTION

The Lightpro Ixion is a LED wall lamp for outdoor use. The
fixture can be fixed to the wall with the included screws.
This product may only be used as outdoor lighting in
combination with the Lightpro 12-volt system. Any
alterations made to the product may have consequences
for the safety, guarantee and correct functioning of the
product and/or other parts of the system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x W x D)
Protection class
Ambient temperature
Cable length
Dimmable
Light source

PACKAGING CONTENT

[Figure A]
1. Fixture Ixion
2. Screws
3. Plugs
4. Lightpro connector
5. Hex key
Lightpro Ixion
182W
LED 9W AC/DC 12V
9W
50-534 lm
3.000K
25.000 Hours
110 x 110 x 110 mm
IP44
-20 °C to 50 °C
3m
Yes
Not replaceable
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl
[Figure B]
Mount the back plate on the wall with the included
screws
If necessary, drill holes in the wall and use the included
plugs
[Figure C]
Place the lamp over the back plate
[Figure D]
Fasten the lamp with the included screws
[Figure E]
Determine the desired light angle by adjusting the
shutters
[Figure F]
Set the desired brightness using the push button
The brightness can be adjusted to 6 different levels
[Figure G]
Place the shade over the lamp
[Figure H]
Fasten the shade with the included screw
[Figure I]
Ready
NB
If desired, the cable can be fed through the wall. Drill a
10 mm hole in the desired position through the wall with
a suitable drill.
Feed the small plug with the cable through the drilled
hole. Fit the plug to the appropriate cable with the
appropriate female plug.