Inhaltsverzeichnis
Werbung
Avior
User manual
Thank you for purchasing the Lightpro Avior.
This document contains the required information for
correct, efficient and safe use of the product. Consult the
user manual of your transformer for more information
about the installation and connection of your lighting
plan or visit our website www.lightpro.nl
Read the information in this manual carefully before
using the product. Keep this manual near the product for
consultation in the future.
PRODUCT DESCRIPTION
The Lightpro Avior is an LED spot for outdoor use. The
fixture can be installed on a fixed underground with
the included screws, or be placed in the ground with
the included spike. This product may only be used as
outdoor lighting in combination with the Lightpro 12-
volt system. Any alterations made to the product may
have consequences for the safety, warranty, and correct
functioning of the product and/or other parts of the
system.
SPECIFICATIONS
Product
Article number
Light source
Power (max)
Luminous flux (max)
Light colour
Average lifetime
Dimensions (H x B x W)
Protection class
Ambient temperature
Cable length
Dimmable
Light source
On/off
PACKAGING CONTENT
1. Fixture Oberon Lo/Oberon Hi
2. Ground spike
3. Screw
4. Plug
5. Lightpro connector
6. Hex key
Check if all parts are present in the packaging. For
questions about parts, service, and any complaints or
other remarks, you can always contact us.
E-mail: info@lightpro.nl.
Avior
181S
LED 16W AC/DC 12V
16W
150 - 1500 lm
3.000K
25.000
125 x 180 x 68 mm
IP44
-20 °C to 50 °C
1m
Yes, with built-in dimmer
Not replaceable
10.000
INSTALLATION
Option 1: placement on a fixed underground or mounting
to a wall
[Figure B]
1. Remove the screw from the base using the included hex
key (Figure A [6]).
2. Remove the fixture from the base.
[Figure C]
• Install the base onto the underground with the included
screws.
If necessary, drill a hole in the underground and use
the included plugs.
[Figure D]
1. Place the fixture in the base.
2. Place the screw in the base.
3. Put the fixture in the desired position.
4. Fasten the screw using the included hex key
(Figure A [6]).
Option 2: placement in the ground
[Figure E]
1. Place the spike underneath the base.
2. Properly fasten the spike.
3. Put the fixture in the desired position.
4. Fasten the screw using the included hex key
(Figure A [6]).
5. Place the fixture in the ground.
DIMMER FUNCTION
The fixture is equipped with a built-in dimmer. The
light output can be set to 6 different levels.
[Figure H]
• Push the button to set the desired light output.
Werbung
Inhaltsverzeichnis
