First Use; Wired Mode - KLIM Lynx Benutzerhandbuch

FIRST USE

Note: it is highly recommended to run a full charging cycle before using the headset for the first time. Refer to
the section "charging the battery" for charging instructions.

Wired Mode

Connect one end of the 3.5 mm cable to the AUX port on the headset, and the other end to a compatible port in
your device.
Note: both audio and microphone are compatible while in wired mode, as long as the port supports audio and
microphone connections at the same time. If your device has one port for audio and one port for microphone,
please use a 3.5 mm audio/mic splitter cable (not included).
USB Transmitter
1. Insert the wireless transmitter into the USB port of your device. Once the driver finishes its automatic
installation, the transmitter enters a stand-by state and the LED indicator turns red.
2. Turn on the wireless headset: it automatically enters pairing mode. Press and hold the button on the
wireless transmitter for 3 seconds to pair the headset to the transmitter. The LED indicator flashes in blue
quickly.
3. Once the headset is paired with the transmitter, the LED indicator stays lit on blue.
After a successful pairing, every time you turn on the headset it connects automatically to your device.
Bluetooth
If the headset is not paired to any device, it enters pairing mode automatically and the light flashes in blue
and green alternatively. If they have been paired with a different device before, reset any previous
connections by short pressing 5 times the Picto button.
When in pairing mode:
1. Activate Bluetooth on your device and open the list of available Bluetooth connections.
2. Select KLIM Lynx to pair the headset with your device.
3. The LED indicator turns blue, and the headset is connected.
After a successful pairing, every time you turn the headset on it connects automatically to your device.
Note: You can only have 1 device connected at the same time. When using the USB transmitter, the Bluetooth
connection is deactivated, and vice versa.
4