Technoline WS 6815 Bedienungsanleitung Seite 4

During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since
the clock is detecting DCF signal and other signals in the air at the same time.Press SET will return
to the time display with
Successful reception or failed reception
icon becomes static on (stop blinking) when reception is successful
icon disappears when reception is failed
Automatic reception and manual reception
Your clock starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF
time signal at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it
fails again, it will start automatic reception at 1:00 again in the next day.
For manual reception simply press and hold
starts manual reception. Press and hold
During RCC reception, all buttons do not function and it does not take temperature and humidity
measurement. The temperature and relative humidity readings will get stable and become more
accurate after your weather station clock is powered up for around 30 minutes.
To cancel DCF reception permanently
Press and hold / WAVE and
beeps and the radio controlled function is permanently disabled.
To resume the radio controlled function, press and hold
seconds, your clock will give 2 short beeps and will start DCF immediately.
Note: Keep in mind that your outdoor transmitter has a 30-meter open air transmission with no
obstructions. Actual transmission range will vary depending on what is in the path of the signal.
Each obstruction (roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.
ZEITEINSTELLUNG
1. Press and hold SET for 2 seconds, hour digits flash. Press
2. Then press SET once again, the minute digits flash. Press
3. Then press SET once again, display shows :05 and flash. Press
duration from 5 minutes to 60 minutes.
4. Press SET to return to normal mode or it will return to normal mode in around 8 seconds if no
further press of any other buttons.
5. Your clock is in 24-hour display format.
ALARMEINSTELLUNG
(default alarm setting is 6:00 AM)
Press and hold ALM, the hour digits flash with "AL" icon flashing. Press
1.
desired alarm hours.
2. Press ALM once again, the minute digits flash. Press
minutes.
3. Press ALM once to store your alarm setting and return to normal time display, or the clock
will return to normal mode in around 8 seconds if no further press of any other buttons.
icon flashing.
/ WAVE to stop DCF reception.
at the same time for 2 seconds, your clock will give 2 short
/ WAVE, your clock will gives a short beep and
/ WAVE and
/
P. 4
at the same time for 2
/ to set hours.
/ button to set minutes.
/ button to set snooze
/
to set your desired alarm
to set your