Cleaning The Grease Filter; Replacing The Lamp - Electrolux EFV618K Benutzerinformation

The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
Charcoal filter

4.2 Cleaning the grease filter

Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Pull the cover to open it.
1
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
1
2
3. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
5. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.3 Replacing the charcoal filter
The charcoal filter must be replaced if
the filter alarm is on.
Refer to the filter notification
in daily use chapter for more
information about function.
WARNING!
The charcoal filter is NON-
washable! The filter cannot
be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Turn the filter counterclockwise (1)
and then pull (2).
To mount the filters back follow the steps
in reverse order.

4.4 Replacing the lamp

This appliance is supplied with a LED
lamp and separate control gear (LED
driver). These parts can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
ENGLISH 31
1
2