Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use proper battery charger.
Use only the Tektronix external battery charger or an approved
Tektronix instrument to charge the lithium-ion battery.
Do not operate without covers.
Do not operate this product with covers or panels removed, or with
the case open. Hazardous voltage exposure is possible.
Avoid exposed circuitry.
Do not touch exposed connections and components when power is
present.
Do not operate with suspected failures.
If you suspect that there is damage to this product, have it inspected
by qualified service personnel.
Disable the product if it is damaged. Do not use the product if it
is damaged or operates incorrectly. If in doubt about safety of the
product, turn it off and disconnect the power cord. Clearly mark the
product to prevent its further operation.
Examine the exterior of the product before you use it. Look for cracks
or missing pieces.
Recharge batteries properly.
Recharge batteries for the recommended charge cycle only.
Do not operate in wet/damp conditions.
Be aware that condensation may occur if a unit is moved from a cold
to a warm environment.
Keep product surfaces clean and dry.
Remove the input signals before you clean the product.
Do not attempt to service this product.
There are no serviceable components in the battery charger.
Safety terms in this manual
These terms may appear in this manual:
WARNING: Warning statements identify conditions or
practices that could result in injury or loss of life.
CAUTION: Caution statements identify conditions or
practices that could result in damage to this product or
other property.
Safety terms on the product
These terms may appear on the product:
•
DANGER indicates an injury hazard immediately accessible as
you read the marking.
•
WARNING indicates an injury hazard not immediately accessible
as you read the marking.
•
CAUTION indicates a hazard to property including the product.
Symbols on the product
When this symbol is marked on the product, be sure to
consult the manual to find out the nature of the potential
hazards and any actions which have to be taken to avoid
them. (This symbol may also be used to refer the user to
ratings in the manual.)
The following symbols(s) may appear on the product.
Compliance information
This section lists the safety and environmental standards with
which the charger complies. This product is intended for use by
professionals and trained personnel only; it is not designed for use in
households or by children.
Direct compliance information inquiries to the following address:
Tektronix, Inc.
PO Box 500, MS 19-045
Beaverton, OR 97077, USA
tek.com
Environmental compliance
This section provides information about the environmental impact of
the product.
Product end-of-life handling
Observe the following guidelines when recycling an instrument or
component:
Equipment
Production of this equipment required the extraction
recycling
and use of natural resources. The equipment may
contain substances that could be harmful to the
environment or human health if improperly handled
at the product's end of life. To avoid release of
such substances into the environment and to reduce
the use of natural resources, we encourage you to
recycle this product in an appropriate system that
will ensure that most of the materials are reused or
recycled appropriately.
This symbol indicates that this product
complies with the applicable European Union
requirements according to Directives 2012/19/EU
and 2006/66/EC on waste electrical and electronic
equipment (WEEE) and batteries. For information
about recycling options, check the Tektronix Web
site (www.tek.com/productrecycling).
Copyright © Tektronix. All rights reserved. Licensed software
products are owned by Tektronix or its subsidiaries or suppliers,
and are protected by national copyright laws and international
treaty provisions. Tektronix products are covered by U.S. and
foreign patents, issued and pending. Information in this publication
supersedes that in all previously published material. Specifications
and price change privileges reserved.
TEKTRONIX and TEK are registered trademarks of Tektronix, Inc.
Contacting Tektronix
Tektronix, Inc.
14150 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
For product information, sales, service, and technical support:
•
In North America, call 1-800-833-9200.
•
Worldwide, visit to
www.tek.com
find contacts in your area.
Warranty
For warranty information, go to
www.tek.com/warranty-status-search
Werbung
