Programming And Setting - Julius Mayer JMVS-1 Montage- Und Bedienungsanleitung

In order to be able to program the sensor, a hand-held or wall transmitter must already be program-
med in the corresponding receiver (Julius Mayer radio receiver).
Each keystroke must be executed within approx. 4 seconds!
Otherwise, the system automatically exits programming mode.
1. Programming the vibration sensor JMVS-1
1. Open the housing and remove the control
unit.
2. Set the trimmer to level "0" with a small
screwdriver.
3. Press button P2 3 times in succession on
an already programmed hand-held
transmitter.
4. Press the P2 button on the JMVS-1 once.
Motor moves up/down briefly.
JMVS-1 is programmed.
5. Set the desired sensitivity of the sensor
on the trimmer.
-start with a low setting (level 1 or 2).
6 Click the control unit into the housing.
7. Slide the housing back onto the rear
cover.
Sensor beeps briefly and is activated.
2. Checking the function
1. Set the front profile of the awning in
oscillation.
CAUTION! Do not move the awning too much!
2. After approx. 2-3 seconds, the awning
must retract automatically.
3. Change the trimmer setting if necessary.
NOTE!
After the retraction command has been
triggered by the sensor, the awning cannot be
extended for approx. 10 minutes (blocking time).
3. Deactivating the sensor
ATTENTION!
Not recommended, as there is a risk of damage
to the sun protection system when the sensor
is deactivated.
- Trimmer at level "0" - JMVS-1 deactivated.
When the set vibration intensity is reached, the retract command is triggered with a delay of approx.
3 seconds and repeated 2 times.
PROGRAMMING AND SETTINGS
P2
3 x P2 - already
programmed
Hand-held trans-
mitter
-
+
+
-
Trimmer
1 x P2
JMVS-1
15