Functional Description - Julius Mayer JMVS-1 Montage- Und Bedienungsanleitung

The JMVS-01 is a battery-operated vibration sensor for motorised awnings.
Incoming wind generates vibrations at the drop profile of the awning.
The sensor can be set to 9 sensitivity levels and sends a retract command to the previous-
ly programmed receiver when the preset sensitivity level is reached (see technical data for
compatible receivers).
1. Slide on the rear cover from the side.
2. Remove the control unit from the housing.

Functional description:

Button P2 = Programming
Trimmer = Set sensitivity
0 = Programming mode
1 = High sensitivity
9 = Low sensitivity*
1 = Batteries (2 x AAA)
Ensure correct polarity!
2 = Beeper
ATTENTION!
The magnet must be in the specified position
when the sensor is assembled.!
The sensor beeps when the housing is closed to
signal activation.
3 = Magnet for read contact
* For folding arm awnings, we recommend an
adjustment of max. level 3.
Please be sure to follow the instructions for
the awning!
NOTE:
If the battery voltage drops below 2.2 V, the sen-
sor beeps at intervals of approx. 5 seconds.
FUNCTIONAL DESCRIPTION
P2
-
2
+
Trimmer
3
1
+
1
-
13