General Safety Instructions - Julius Mayer JMVS-1 Montage- Und Bedienungsanleitung

GENERAL SAFETY INSTRUCTIONS

EN
WARNING!
Important safety instructions!
• For the safety of persons it is im-
portant to follow these instruc-
tions!
• Please keep the instructions and
hand them over to the new owner
when changing ownership!
• This appliance can be used by chil-
dren aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities, lack
of experience and knowledge if
they have been given supervision
or instruction concerning use of the
appliance in a safe way and under-
stand the hazards involved.
• Children must not play with the
appliance.
• Cleaning and maintenance by the
user must not be carried out by
children without supervision.
WARNING!
The motor controlled by the wireless
vibration sensor must be disconnec-
ted from its power source during cle-
aning, maintenance and replacement
of parts.
WARNING!
Failure to comply may result in dan-
ger to life!
There is a danger to life from electric
shock when working on electrical
equipment!
Observe the instructions and safety
instructions of the drive / receiver
controlled by the sensor as well as
the corresponding instructions of the
driven sun shading system!
10
ATTENTION!
It is essential to observe the follo-
wing instructions!
The range of radio controls is regu-
lated by the legal provisions for ra-
dio installations and is influenced by
structural conditions, among other
things.
When planning, make sure that there
is sufficient radio reception.
This is especially true if the radio
transmitter is located in a different
room than the radio receiver and the-
refore the radio signal must penetrate
walls or ceilings.
Do not install the radio control in the
direct vicinity of large metallic surfa-
ces.
Other transmitting devices (e.g. radio
headphones, baby monitors, radio
weather stations) whose transmissi-
on frequency is identical to that of the
radio control unit may interfere with
reception.
ATTENTION!
Instructions for correct use and the
conditions of use must be observed!
Improper use increases the risk of da-
mage to the sun shading system!
• Only use the radio control (the
sensor) for connection to roller
shutter, awning and blind motors.
• Mount the sensor from sen, lateral-
ly, horizontally, on the drop profile
of the awning.
The sensor must be mounted in such
a way that a measurement can be
taken without interference!