Tweeter Mounting; Midrange Mounting - RA Audio RA13.2 Bedienungsanleitung

TWEETER MOUNTING

The RA28 tweeter units need to be flush mounted to a panel or surface. This
requires holes to be cut. After you have visibly determined which tweeter
mounting location in your vehicle provides space for the tweeters, proceed as
follows:
Q Mark the centre of the spot where the tweeters are going to be mounted
with a felt tip marker.
Q Remove the panels, and check for proper clearance behind it. The required
mounting depth is 28.5mm, double check before cutting holes into plastic
surfaces or sheet metal.
Q Use a 3mm drill bit to drill a pilot hole, then use a hole saw attachment for
your power drill to widen up the pilot hole to become 50mm in diameter.
Q Stick the tweeter through the hole you have cut, attach the cross blade to
the backside of the tweeter by inserting the M4 screw into the brass thread
on the tweeter backside.
Q Connect the tweeter lead wires to the extension cable that goes to the
crossover.
Q Remount panels.

MIDRANGE MOUNTING

Q Caution, only for RA16.3 Set
The RA50 dome midrange units come with two different mounting adaptors,
one suitable for flat surface of flush mounting, the other for angled mounting
inside a 85mm OEM speaker cutout in the dash board.
Q Remove the panel you are going to install the RA50 dome midrange unit
and check for proper clearance behind it. Flush mounting of the midrange
speaker needs at least 31mm clearance to the backside. Make sure there are
no obstructions behind the spot you choose.
Q Mark the centre of the spot with a felt tip market and remove the panel.
Q Predrill a pilot hole with a 3mm drill bit. Widen up the hole to become
75.5mm in diameter, using either a jigsaw or a hole saw attachment for your
power drill.
Q Mount the four metal spring clips to the mid/range unit, placing them into
the small grooves / recesses on the front rim of the RA50 unit.
Q Connect the mid/range speaker to the extension wire that goes to the
crossover.
Q Mount the trim ring of the grille with four screws on top of the hole you have
cut before and insert the dome midrange unit into this hole, by pressing the
metal clips together.
Q Attach the metal mesh grille to the trim ring, and remount the panel to the
vehicle.
RA16.3 Manual 9
9
11.11.2005 10:38:09 Uhr