Troubleshooting Guide - oglo# MS-O-700-D Bedienungsanleitung

troubleshooting guide

Before contacting the service department, please carry out the checks listed below. If you cannot solve
the problem by following the instructions below, contact your store.
SYMPTOMS
The mini-stereo
does not switch on.
No sound.
Malfunction.
The remote control
is not working.
There is no
playback on the
USB media.
The Bluetooth
*
connection cannot
be established.
30
POSSIBLE CAUSES
The appliance is not plugged in.
There is no power at the mains plug.
The volume is set to minimum or is muted.
The selected source is not correct.
The mini-stereo works abnormally, or
emits an unusual sound.
The distance between the remote control
and the mini-stereo is too great.
There is an obstacle between the remote
control and the appliance.
The battery is flat.
The selected source is not correct.
The playback format is incorrect.
Removable media is not detected.
Your audio source is not in pairing mode.
Make sure that the mini-stereo and your Bluetooth* device are less than 8 metres
apart and that no walls or electronic devices are obstructing the transmission.
SOLUTIONS
Plug the appliance into a mains socket.
Connect another device to the same
power outlet to cross-check the outlet.
Adjust the volume.
Briefly press the button
buttons VOL+ or VOL- to turn the
volume back on.
Select the appropriate audio source by
pressing the button
Unplug the appliance for 30 minutes.
After 30 minutes, turn the mini-stereo
back on.
Bring the remote control closer to the
appliance.
Remove any obstacles between the two
objects.
Replace the battery. Refer to "The
Remote Control - Replacing the Battery"
section.
Select the USB source by repeatedly
the button
pressing
Check the playback formats compatible
with this appliance (MP3/WMA).
Unplug the removable media and plug it
in again.
Refer to the user manual of your audio
source for more details.
or the
several times.
.