Safety Instructions; Technical Data - Kayoba 022864 Bedienungsanleitung

EN

SAFETY INSTRUCTIONS

• Failure to handle batteries carefully and/
or incorrect use can result in a risk of fire,
explosion, deformation and/or leakage,
which can in turn result in personal injury
and/or material damage. Follow all the
instructions and safety instructions.
• Avoid contact with battery fluid. If you get
battery fluid on your skin or in your eyes,
rinse immediately with water for at least
10 minutes and then seek medical attention.
• Switch off the product immediately with
the power switch if the battery emits
smoke or an abnormal smell.
• Only charge the battery with the supplied
charger cable.
• Do not overcharge the battery. Unplug the
charger cable when the battery is fully
charged.
• Do not leave the battery unattended
when charging.
• Allow the battery to cool before charging.
• Remove the batteries from the product
and the remote control when the product
is not in use.
• Do not expose batteries to high
temperatures. Do not burn batteries.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Battery type, remote control 2x AA (LR6) 1.5 V
Frequency, radio signal
Size
16
2.4 GHz
L42xW12xH20 cm
DESCRIPTION
Dinosaur with audio and light functions that
are controlled via the supplied remote control.
Rechargeable battery and charger included for
the dinosaur. Batteries for the remote control
are not included and are sold separately in
Jula's department stores and at www.jula.com.
Package contents
1. Dinosaur
2. Remote control
3. Battery
4. USB charging cable
5. Instructions
USE
BATTERY
Inserting the battery
Open the battery cover underneath the
dinosaur and insert the rechargeable battery.
FIG. 1
NOTE:
When the battery is in place, put the power
switch in position ON to set the right frequency.
PAIRING
Switch on the remote control first, the LED
indicator on the remote control starts to
flash. Then switch on the dinosaur, the back
lighting of the dinosaur starts to flash and the
red indicator on the remote control will turn
off, which means paring is successfull. lf the
dinosaur is turned on first, just turn on the
controller and play with it, if it does not work,
try to turn off the controller and the dinosaur,
then start paring again or recharge the battery
of the dinosaur.