Modecom MC-1001 HF Bedienungsanleitung Seite 15

UK
MODECOM
Bluetooth & Noise Canceling Headphone
MC-1001HF
1 Noise canceling LED
2 USB charging port
3 Noise canceling on/off buton
4 Bluetooth LED
5 3.5 mm line-in port
Battery charging
Connect the appropriate connector on the accessory micro-USB cable to the micro-USB port
on the headphones, and the USB plug on the other end to a USB port on a computer.
When recharging begins, the LED indicator on the headphones will light red.
Full recharging requires about three hours; when recharging is completed, the LED indicator
will turn off.
When the battery' s charge is approaching depletion, a beep sound will be heard in the
headphones at one-minute intervals.
Pair headset with Bluetooth devices
1. With the headphone power OFF, hold MFB button depressed for three seconds or more
to power on and enter the pairing mode. The pairing mode is confirmed by the LED
indicator's flashing blue and red.
2. When in the paring mode, if pairing is not completed within about five minutes, the
power will automatically turn off.
3. Turn on the power to the bluetooth device you wish to pair with, and begin pairing;
search for this unit from the paired bluetooth device. Set the bluetooth device within
one meter to the wireless headphones. These wireless headphones will appear in the
bluetooth device's display as "MC-1001HF".
4. Confirm that pairing has been successfully completed with the bluetooth device. Look
at the display for the bluetooth-enabled device and select "MC-1001HF" . Pairing is
confirmed when the LED indicator flashes blue at the intervals of three seconds.
The PIN code for these wireless headphones has been factory set at "0000" . Input this
code if requested by the bluetooth device.
6 Volume down
7 MFB button
8 Volume up
9 Cushion
10 Headband
Notes:
1. When the headphone already paired with a device, it will alternately connect when both
devices powered on and stay within 1m. If you want to pair with another device, please
disconnect the previous device first.
2. If the pairing is not successful, please switch off headset firstly and then re- pair again.
Noise Canceling Function
When you slide the NC button to the "On" side, the indicator will turn on, then you can enjoy
the headphone in Noise cancellation mode. When you don't need the Noise cancellation
function, please slide the NC button to the OFF side.
Making calls with the headset
FUNCTIONS STATUS OF
HEADSET
Redial Last number Standby mode
Volume up Conversation mode
Volume down Conversation mode
Answering calling Ringing
Reject calling Ringing
Notes:
Not all the mobile phones support all the functions listed above. Please refer to the
instruction of your mobile phone. Some functions and indication tones may vary with
mobile phones
Playing Music
To use the wireless headphones to listen to music form a bluetooth device, you must first
perform pairing with the bluetooth device using the A2DP audio profile.
Controls when listening to music
( + ) button
Press once: increase the volume
Press and hold: advance to next track or chapter
( - ) button
Press once: decrease volume
Press and hold: return to beginning of track or chapter.
MFB button
Press once: play/pause
• When sound volume is set to maximum or minimum levels a beep sound will be
produced from the headphones.
• Depending on the specifications of the connected bluetooth device, the controls noted
above and controls on the bluetooth device may not be supported.
Disconnecting from the bluetooth device
Hold the wireless headphones MFB button depressed for about five seconds to turn off the
power.
OPERATION
Short press MFB twice quickly
Short press "+" button
Short press " - " button
Short press MFB button
Press and hold MFB button for one
second, and release
until you hear indication
sound
15