Product Features - nedis ANIR2503BK700 Kurzanleitung

ANIR2503BK700_MAN_COMP_print_1022.indd 6 ANIR2503BK700_MAN_COMP_print_1022.indd 6
• Install the antenna as high as possible: In digital terrestrial
reception, interceptions between antenna and transmission
tower will cause signal loss temporarily. Please install the
antenna as high as possible to reduce interceptions.

Product features

• Variable gain control.
• Power On/Off LED indicators.
• SMD circuit technology design.
• Built-in high gain and low noise amplifier.
• Adjustable loop aerial for the best UHF reception.
• Adjustable telescopic antennas for optimum VHF and FM
radio reception.
• Compatible with HDTV of various digital terrestrial signal
(DVB-T, ISDB-T, DMB-T/H, ATSC) and DAB/FM radios.
Installation
1. Connect the AC 230V cable to the 230V AC wall socket.
2. Connect the TO TV cable to the antenna-input socket of
your Tv or terrestrial DTV set-top-box.
3. After checking that all the connections have been done
properly, turn on the power switch to switch the antenna
on: LED lights up showing that the amplifier of indoor
antenna is working.
4. Now, turn your television set on and select a TV program,
then adjust the rod antennas, the UHF dipole, The UHF
reflector and the amplifier gain adjuster knob according to
what is described in next paragraphs.
Signal reception
VHF signals - I-III BAND (channels 1 - 12)
This antenna receives VHF signals (both analog and digital)
through the rod antennas. For the best reception, adjust rod
antennas as follows:
• For I Band: extend completely the rod antennas.
• For III Band: shorten the rod antennas to about 16 inches
(the extension depends on the channel you want to
receive);
• Then, move the rod antennas until you get the best signal
reception.
UHF signals – IV-V BAND (channels 21 - 69)
This antenna receives UHF signals through dipole antenna:
1. Turn the UHF reflector sideways.
2. Turn the UHF dipole in anticlockwise direction until you get
the best signal reception.
6
10-10-2022 08:36:02 10-10-2022 08:36:02