Product Characteristics - YATO YG-04301 Originalanleitung

GB

PRODUCT CHARACTERISTICS

The boiling pot for water is a professional product, which allows for cooking and heating water and its distribution. Due to installed
an adjustable thermostat, there can be set any temperature of the operating range of boiling pot. Correct, reliable, and safe opera-
tion of the device is dependent on its proper use, therefore:
Prior to working with the product, you should read all the instruction and keep it around.
For any damages or injuries caused by the product misuse, non compliance with with safety regulations and recommendations
included in this manual, the supplier does not accept any liability. Using the product incorrectly, causes also the loss of user's
rights to the guarantee as well as a warranty.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. Before using the product you should, however, remove all
packaging and protection for transport. They are also required preparatory steps described later in this manual.
GENERAL RECOMMENDATIONS FOR USE
The product has been designed for professional use and its operation should be carried out
by properly qualifi ed personnel. The product is only used for water heating and cooking. It is
forbidden to pour other liquids to the boiling pot. It is forbidden to repair independently, disas-
sembly or modifi cation of the product.During the operation, you should supervise the product
all the time. WARNING! During its operation the product heats up to high temperatures, you
should not touch the walls of the product during its operation, it may cause serious burns. The
product is not intended for use by children at least 8 years of age and persons with reduced
physical abilities, mental abilities and people with lack of experience and knowledge of the
equipment. Unless there will be supervised or instruction will be carried out regarding the
use of the product in a safe manner so, so that the associated risks would be understood.
Children should not play with the product. Children without supervision should not carry out
the cleaning and maintenance of the device.
Recommendations for transport and installation of the product
ATTENTION! Installation and connection of the product may be made only by qualifi ed per-
sonnel. The product may only be placed on a hard, fl at, even and non-fl ammable surface.
The substrate should withstand the weight of the device, and the water it contains.There
should be ensured a space of at least 10 cm all around the product and at least 30 cm above
the product. This will allow for proper ventilation of the product. Do not place eg. a table
near the edge. On the product you should not place any objects.Do not place the product
so, the tap would be outside edge eg. the table. This can lead to accidental opening of the
valve which can cause serious burns.Under the tap outlet you may put a drainboard, which
would help to protect the fl oor against possible splashing of water when emptying the tank.
Any electrical devices should be placed above the product. During operation water vapor is
released, it can cause an electrical short circuit and cause electric shock. It is forbidden to drill
any holes in the product, as well as any other product modifi cation, which is not described
in the manual. The products should be transported only by handles. The temperature at the
place of installation and operation of the product must be in the range of + 10 C ÷ +38 C,
O O
and relative humidity must be below 90%.
Recommendations for the fi lling of the product with water
O R I G I N A L I N S T R U C T I O N S
8