Kress KUF30.9 Originalbetriebsanleitung Seite 8

WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
8
ACCESSORIES
EN
Blower tube
Dust cover
Blowing mouth
Small hose
Quick change connector
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the blower. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
NOTE:
• Remove the battery before carrying out any
adjustment, servicing or maintenance.
• Make sure that ON/OFF Switch is on ''O''
position before assembling or removing any
accessories.
ASSEMBLY AND OPERATION
ASSEMBLY
Assembling the blower tube
Assembling blowing mouth
Assembling Small hose, quick
change connector, dust cover
OPERATION
Installing & removing the battery
pack *
Using the variable speed dial (I,
II, III)
Starting & Stopping
WARNING! The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool
down.
Using the blower
USER TIPS
- Hold the blow tube approx
180mm above the ground when
operating the tool.
- Use a sweeping motion from side
to side. Advance slowly keeping
the accumulated debris/leaves in
front of you.
1
- After blowing the debris/leaves
into a pile, it is easy to dispose of
1
the pile.
1
Caution!
2 (Φ6, Φ8)
-Do not operate the blower
near bystanders or pets.
2
-Use extra care when
cleaning debris from stairs or
other tight areas.
-Wear safety goggles or other
suitable eye protection, long
pants, and shoes.
- Keep bystanders away.
-Do not blow any hot
flammable or explosive
materials.
Action
See Fig. A1, A2
See Fig. B
See Fig. C1, C2,
C3, C4
See Fig. D
See Fig. E
See Fig. F
See Fig. G, H
Figure