Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Guide
3
Installation
3.1
Installation
3.1.1
Assembling the wall bracket
6
Athena wall bracket
▪ Insert the screws through the washers into the rail supports.
▪ Secure the screws with the slide nuts. Ensure that the knurled sides of the slide
nuts are facing the screws.
▪ Wind the screws into the slide nuts by a couple of turns.
▪ Guide the rail supports to the top end of the system rails. For this, hold the rail sup-
ports against the open side of the system rails.
▪ Slide the rail supports over the system rails by inserting the slide nuts into the sys-
tem rails.
▪ Ensure that the slide nuts are aligned in the right angles to the system rails.
▪ Pull the rail supports along the system rails to the required height.
▪ Tighten the screws by hand.
ACAT05IG0102
Thermia AB
Werbung
Inhaltsverzeichnis
