Installation; T-Stand - Thermia Athena T-Stand Installationshandbuch

Installation Guide
4

Installation

4.1

T-stand

1. Clearance dimensions, lower support
▪ Set the lower supports in the foundation holes.
▪ Ensure that the lower supports protrude the required height from the ground, as shown in the image above.
▪ Set suitable spacers to assist with the distance, for example bricks.
1
1. Installation template.
2. Anti-vibration mounts with inserted threaded pins.
▪ Insert the threaded pins as far as they will go into the anti-vibration mounts.
▪ Position the installation template onto the supports, as shown in the image above.
▪ Insert the anti-vibration mounts with the threaded pins through the installation template into the lower supports.
▪ Counter the threaded pins from below the supports using the nuts. Tighten the nuts by hand.
▪ Check that the T-stand is horizontally and vertically level, using a spirit level.
▪ If required, level the T-stand by moving the spacers.
Use a concrete that is compatible with stainless steel.
▪ Fill the foundation holes with concrete and consolidate the mass.
▪ Let the concrete cure, according to the manufacturer's instructions.
▪ Remove the anti-vibration mounts, the installation template and the spacers.
6
Athena T-Stand
2
ACAT02IG01
400-500
Thermia AB