Cycle2Charge V3 Plus Bedienungsanleitung Seite 25

User manual
7
The USB-charger Cycle2Charge converts the energy of
the dynamo in 5V DC voltage to power USB-devices.
The maximum charge current must stay below 1A.
To use the Cycle2Charge, the black top cap must be
turned until the USB-outlet is accessible.
If no cable is connected to the USB outlet, the top cap
has to be turned by 180° to protect the device from
water and dirt.
On new products the black cap might move stiffly at the
beginning. This will change over time. A certain
resistance is needed to prevent an unwanted movement
of the cap.
The USB-cable used should be as short as possible.
Especially cheap long USB cables show a significant
energy loss.
You should either charge a device or switch your
bicycle lights on as a simultaneous usage will reduce the
light energy and the charging speed significantly.
If you want to use the charging function you should
Bedienungsanleitung / User Manual Cycle2Charge Rev08 25/28