Installation - Bego Regulus Originalbetriebsanleitung

English ⋅ Regulus
en

Installation

WARNING
• Only connect Regulus to cold pre-
heating ovens.
• When laying cables and hoses,
ensure that they are protected from
hot components!
• The machine must only be connect-
ed to the socket provided on the
rear of BEGO pre-heating ovens.
18
WARNING
• Drain condensation water that is
collecting in the supplied extraction
hose into a preferably heat-resist-
ant, sealable container and dispose
of it regularly.
• Place the preheating oven with
Regulus under an extraction hood, if
possible.
Always discharge vapours out-
doors.
1. Push on the hose (1) and secure with the hose
clip (2).
2. Push the two parts of the connector together to
make it as long as possible so that the exhaust
fumes/gases are directly channelled into the
exhaust hood.
3. Screw the assembled fan onto the connector
on the rear panel of the oven (3).
4. Insert the plug into the socket at the rear of the
oven.
NOTE
The Regulus extraction pipe can be extended by
up to 2 m with normal commercial 80 mm dia.
pipes.
Always discharge vapours outdoors!