Mounting; Connection; Technical Data - Viessmann 1500 Bedienungsanleitung

Caution!
First carefully remove adhesive gum from the back of the door.
The integrated programme control allows the door to be opened and closed at
random or by means of a contact (push-button, track contact).
The specially designed drive unit is equipped with an electronic control generating
realistic movements. The drive unit is firmly attached to the model.
Attention: If you have to unmount the model, never pull at the model itself. Care-
fully seize the article by its drive unit instead and push it up.

3. Mounting

1. Drill a hole of 12 mm diameter at the mounting place (fig. 1).
2. Insert the connection cables into the hole from top.
3. Slide the cylinder with the drive unit/control into the hole until it rests on the
surface with its upper edge (fig.1).
4. Fasten the model to the layout with the enclosed retaining ring. Slide the ring
over the drive unit until it is fixed. Turn the ring by 90° to lock it.

4. Connection

Connect the model to an authorized model train transformer (e. g. item 5200).
Simply use an ordinary switch such as item 5550 for switching the model on and
off (fig. 2).
Caution:
Do not leave the functional model unattended while it is switched on. Turn it off
when not in use.

5. Technical data

Connections:
Power supply:
Operating voltage:
10 – 16 V AC ~ (with and without Viessmann power module, items 5215/5205)
Operating current:
Standby current:
System:
Length of drive unit:
yellow, brown
14 – 24 V DC =
13 – 24 V Digital signal
< 100 mA
< 30 mA
analogue
39 mm
5