Troubleshooting Guide - Ufesa FLEXY-HEAT BM Bedienungsanleitung

ERGONOMIC LINE - FOOT CARE
This product is specially designed to anatomically adapt to the body's lower extremities,
providing a perfect fit.
The application of dry heat provided by the Flexyheat BM blocks cold and moisture from
reaching the lower limbs, providing a pleasant sensation and well-being.
INSTRUCTIONS FOR USE
Before plugging in the Flexyheat BM boot to the main electricity supply, check the voltage
of your wiring installation, as it must be the same as the one indicated on the product
label. Plug the product into a suitable power socket.
To turn on the product, you must slide the control switch to the 1, 2 or 3 setting (Fig. 1).
From this point on, the boot is now operational.
The maximum operating time is 3 hours, after which an automatic safety stop will be
triggered. At this point, the product will stop heating.
To turn off the product before unplugging the device from the power supply, you must
select the "0" setting.
To turn on the product again, set it to position "0" and select the desired temperature.
When storing the product, let it cool before folding it and do not stack other objects on top
of it.

TROUBLESHOOTING GUIDE

Possible operational problems
PROBLEM
The control knob does not light up when the
switch is operated.
After a period in operation, the boot temperature
seems to decrease.
The product reaches internal temperatures of between 50º and 60ºC. This temperature is
only a guideline. The measurements are carried out under laboratory conditions, according
to the procedure described in UNE-EN 60335-2-81.
18
RECOMMENDATION
Make sure the power supply reaches the socket,
and that the product is correctly plugged into it.
The product has an auto power off system after
3 hours of continuous operation. After this time
the adjuster light begins to blink. If you want to
continue using it, change the temperature level
to 0, wait for a few seconds and then select the
desired temperature again.