ND tackle SMART BITE WATCH Bedienungsanleitung Seite 7

HOW TO REMOTE CONTROL FUNCTIONS OF BEA/TH9s via R16
1.Press and hold the 'multifunction button' to enter the system menu of R16 (receiver).
2.Choose menu ´Remote setup`.
1.Remote setup
2.Register alarm
3.Vitual band
4.Range test
5.Drop back set o
6.Date time set
7.Motor on
3. Scroll up and down to select the channel of the registered bite alarm.
set RED
set GREEN
set RED
set GREEN
set BLUE
set BLUE
set YELLOW
set WHITE
set Light
set YELLOW
set Camera
set WHITE
set Light
4.Press buttons 2 (up) and 4 (down) to navigate up and down. Use the multifunction
knob to select an entry, then use 2 and 4 to set the value.
*Some functions depend on the type of bite alarm. Not every bite alarm has all functions.
For example, the S9 and N1 bite alarms do not have a night light.
RED RED
Volume 6 Volume
Tone 6 Tone
Sensitivity 6 Sensitivity 6
Nightlight auto Nightlight auto
Snag Bar Snag Bar
5. You always navigate back with button 1 (power on/o ).
UK
set Camera
set A-EFT1
set A-EFT2
set A-EFT3
set A-EFT4
RED
6 Volume 6
6 Tone 6
Sensitivity 6
Nightlight auto
Snag Bar
RED
Volume 6
Tone 6
Sensitivity 6
Nightlight auto
Snag Bar
9
RANGE TEST
The Range test function does not test the maximum range of the bite indicators to the receiver,
but how far the remote control mode reaches. There is a di erence between the range from the
bite indicator to the receiver and from the receiver to the bite indicator.
The real range of the bite indicator depends on environmental conditions. This range can only
be tested manually by turning the roller wheel.
10
UK