Meccanica Fadini SIBLI 17 Anleitung Seite 4

SIBLI 17
INOX - removable
FITTING OPERATIONS
1)
Provide a suitable foundation plinth made of reinforced concrete, according to the rule of the art, for the stainless steel housing
socket, following the dimensions indicated in the drawing. The reinforced metallic structure (not supplied by the manufacturer)
is to be positioned around the socket very close to it, between the 4 jutting hubs and the top flange.
It is recommended that the housing socket is positioned in such a way that it is 20 mm higher than the finish level.
Drill some holes of 5 - 6 mm diameter in the bottom of the housing socket, allowing water to flow out and away through the
gravel soak-away.
Ground socket Sibli 17
Metallic framework to be provided
as a reinforcement to set in the
concrete foundation around
the stainless steel socket
Gravel layer to provide a soak-away
system
0.0
SECTION VIEW OF THE PLINTH
3851
GB
Drwg. No.
Ø 10 n° 12 pcs.
500
~ 65x65 cm
foundation plinth
INSTRUCTIONS SIBLI 17
CATAWAY DRAWING OF THE PLINTH
Ground socket Sibli 17
20 mm approx.
higher than
pavement
Metallic framework to be provided
as a reinforcement to set in the
concrete foundation around
the stainless steel socket
Concrete foundation plinth
Bottom of the socket to be bored
for water drainage
Gravel layer
for water drainage