Typ2 Auf Typ2 - ABSINA 52-230-1001 Bedienungsanleitung

• Only connect the charging cable to vehicle inlets and
household sockets that are protected from water,
direct sunlight, moisture and other liquids.
• There are electric vehicles that allow the vehicle to be
started with the charging cable plugged in. Always
make sure to disconnect the charging cable before
driving off.
• Do not use the charging cable with an extension cable
or an adapter. Modifications or alterations are
dangerous to life and lead to the immediate exclusion
of the warranty.
• If the plug connection smokes or melts, never touch
the charging cable. If possible, stop the charging
process. Switch off the power to the relevant mains
socket (fuse, FI, switch).
• Make sure that the charging cable is not accessible
to children. Only persons with a valid driving
licence for motor vehicles may operate the
charging cable.
Start charging
1
1
End charging
1
1
WALLBOX
A
WALLBOX
OPERATION
1. Read the instructions for the charging cable and
2. Switch off the vehicle engine. Go to parking mode.
3. Connect the mains plug of the charging cable to a
4. The charging cable performs a self-test during
5. The POWER LED lights up to indicate that the unit is
6. Pull the protective cap off the charging plug and
7. Charging starts automatically as soon as the
8. The charging process is completed when the
9. When charging is complete, disconnect the charging
10. Put the protective cap on the charging plug and roll
SchuKo
SchuKo
2
2
2

Typ2 auf Typ2

2
Typ2 auf Typ2
Deutsch . English
your vehicle completely and carefully.
suitable socket (230V 16A).
which all LEDs light up briefly.
ready for charging.
connect the plug to the charging socket of your
vehicle.
CHARGE LED starts flashing green.
CHARGE LED lights up green continuously.
plug of the charging cable from the charging socket
of your vehicle and then disconnect the mains plug
from the mains socket (vehicle must be unlocked).
up the cable without kinks.
3
3
3
3