Operation; Commissioning; Work Preparation; Changing The Tool Drum - Von Arx DTF 25 SH Betriebsanleitung

DTF 25 SH • Operating Manual

OPERATION

Commissioning

Machines with electric motors
The CEE plug 32A is also supplied for countries in which this plug system has not been intro-
duced.
• An extension cable must be available for connection to the machine. Unroll the extension
cable completely from the cable drum. Only use permitted extension cables.
• Switch the machine on briefly and compare the direction of rotation of the motor with the
arrow on the fan cover. If necessary, change the direction of rotation by phase reversal.
(Changing the phase in the CEE plug).

Work preparation

Check your machine for damage.
• Check whether moving parts are in working order.
• Damaged protection devices and parts must be expertly repaired or replaced by a customer
service workshop.

Changing the tool drum

Pull out the mains plug
1. Remove the cover nuts / countersunk screws from the drum cover
2. Remove the drum cover from the machine
3. Loose the shaft nut and remove the tool drum from the drive shaft
4. Clean and grease the drive shaft lightly.
5. Push the tool drum onto the drive shaft and fasten the shaft nut.
6. Screw the drum cover back on with the cover nuts countersunk screws. (torque values =76Nm)
1
4
2
5
Operation
3
6
9