Daily Maintenance; Cleaning The Humidifier; Cleaning The Atomizer Sheet And Base Channel - Tekno Point inosens CS-UMIDY Gebrauchs- Und Installationshandbuch

ENGLISH
If the device remains off for a long time, it must be emptied and cleaned. While emptying the humidifier,
make sure that no water gets into the lower part.
1 - remove the protection on the float
2 - open the lid and add water
3 - close the lid, attach the nebulization tube and turn on the device
Plug in the power cord, press the power button (not if the tank is empty of water), the device starts in high
mode. If you want to change the nebulization level, adjust it using the regulator located on the front.

Daily maintenance

In some geographic areas, water can be high in calcium and magnesium. These impurities can lower the
efficiency of the device

Cleaning the humidifier

It is recommended to clean the ultrasonic atomizer, water tank and air filter once a week using distilled
water. Frequently change the water in the humidifier to keep it clean. If the humidifier is not used for a
long time, empty the water tank. Clean all parts of the machine before storing it for a period of non-use.

Cleaning the atomizer sheet and base channel

To clean the components, dilute the detergent and pour it into the base, adding water at 45 ° C. Leave for
10 minutes and lightly scrub the surface with a brush. Wash the base with a 1: 1 solution of water and
white vinegar or water and citric acid. Then rinse with water.
TEKNO POINT ITALIA S.R.L. - VIA DELL'ARTIGIANATO 5 - 30020 MARCON (VE) – ITALY
COMMERCIALE@TEKNOPOINT.COM – WWW.TEKNOPOINT.COM
MUI_CS-Umidy_Ita_Eng_Fra_Deu_TP/Rev.00/Data 28.09.2020
13