Connecting The Appliance To The Mains; Switching The Appliance On And Off; Switching On The Appliance; Switching Off The Appliance - Pacojet 2 PLUS Bedienungsanleitung

6.4 Connecting the appliance to the mains
The connecting cable and mains plug (7) are located on the right-hand side of the appliance.
When using a extension cord, make sure it is earthed in accordance with the relevant regula-
tions.
Note
Damage to property caused by incorrect electrical connections!
Failure to observe the necessary specifications for electrical connections may
result in damage to the appliance.
• The Pacojet 2 PLUS must always be operated in accordance with the specifications
for electrical performance listed on the type plate (see also chapter "13. Technical
specifications" on page 42).
• The mains voltage must never deviate from the specified value by more than 10 %.
6.5 Switching the appliance on and off
6.5.1 Switching on the appliance
Repeat function not available.
If the combination of spray guard and processing tool is attached to the
appliance before it is turned on, the repeat function will not be available.
6.5.2 Switching off the appliance
Switch off the appliance by moving the mains switch (7) to position "0".
Warning
Risk of severe injuries caused by defective electrical compo-
nents!
• Always check the appliance for damage before use.
• Never use the appliance if it is damaged.
• Always have the appliance repaired by an official service part-
ner.
Switch on the appliance by moving the mains switch (6)
to position "I". The appliance is in "operating mode".
The mains switch lights up green and the start menu ap-
pears on the display. From here the three basic processing
methods (pacotizing, chopping/cutting, whipping/mixing)
as well as the submenu can be selected.
EN
19